Ford Focus Service Manual: Connecting Rod Large End Bore

Ford Focus Service Manual / Powertrain / Engine / Engine Block / Cylinder Block / Connecting Rod Large End Bore

NOTE:

Refer to the appropriate Section 303-01 for the specification.

Tighten the bolts to specification, then measure the bore in 2 directions. The difference is the connecting rod bore out-of-round. Verify the out-of-round is within specification.

Connecting Rod Cleaning

NOTICE: Do not use a caustic cleaning solution or damage to connecting rods can occur. NOTE: The connecting rod large end is a matched set. The connecting rod cap must be installed on the or ...

Connecting Rod Twist

Special Tool(s) Feeler Gauge Set 303-D027 (D81L-4201-A) or equivalent NOTE: Refer to the appropriate Section 303-01 for the specification. Using the Feeler Gauge ...

More about Ford Focus:

Ford Focus Bumper Cover - Rear
NOTE: Sedan shown, coupe similar. Item Part Number Description 1 17D948 RH/ 17D949 LH Bumper cover brackets 2 17K835 Bumper cover assembly 3 W714665 Fender splash shield-to-bumper cover pin-type retainers (2 required) ...