Ford Focus Service Manual: Connecting Rod Cleaning
NOTICE: Do not use a caustic cleaning solution or damage to connecting rods can occur.
- NOTE:
The connecting rod large end is a matched set. The connecting rod cap must be installed on the original connecting rod in the original position. Do not reverse the cap. Parts are not interchangeable.
Mark and separate the parts and clean with solvent. Clean the oil passages.
Connecting Rod Bushing Diameter
NOTE: Refer to the appropriate Section 303-01 for the specification.
Use a telescoping gauge to determine the ID of the connecting rod bushing,
if equipped.
Measure the telescop ...
Connecting Rod Large End Bore
NOTE: Refer to the appropriate Section 303-01 for the specification.
Tighten the bolts to specification, then measure the bore in 2 directions.
The difference is the connecting rod bore out-o ...
More about Ford Focus:
Ford Focus Cylinder Block Distortion
Special Tool(s)
Feeler Gauge Set
303-D027 (D81L-4201-A) or equivalent
NOTE: Refer to the appropriate Section 303-01 for the specification.
NOTE: Use a Straightedge that is calibrated by the manufacturer
to be flat within 0.005 mm (0.0002 in) per running foot ...
Nissan Frontier - Instrument Panel - Keys - Brake system
