Ford Focus Service Manual: Coolant Pump
Material
| Item | Specification |
|---|---|
| Motorcraft® Premium Gold Engine Coolant VC-7-B (US); CVC-7-B (Canada) | WSS-M97B51-A1 |
Coolant Expansion Tank
| Item | Part Number | Description |
|---|---|---|
| 1 | W701107 | Coolant expansion tank bolt (2 required) |
| 2 | 8C045 | Coolant expansion tank |
Coolant Pump
| Item | Part Number | Description |
|---|---|---|
| 3 | W500221 | Coolant pump pulley bolt (3 required) |
| 4 | 8509 | Coolant pump pulley |
| 5 | W500015 | Coolant pump bolt (3 required) |
| 6 | 8501 | Coolant pump |
| 7 | 8507 | Coolant pump O-ring seal |
Removal and Installation
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02.
- Remove the 2 bolts and position aside the coolant expansion tank.
- To install, tighten to 4 Nm (35 lb-in).
- Loosen the 3 coolant pump pulley bolts.
- Remove the accessory drive belt. For additional information, refer to Section 303-05.
- Drain the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding in this section.
- Remove the 3 coolant pump pulley bolts and the pulley.
- To install, tighten to 20 Nm (177 lb-in).
- NOTICE: Make sure the coolant pump is correctly seated to the engine
block before installing and tightening the fasteners, or damage to the coolant
pump may occur.
Remove the 3 coolant pump bolts and the coolant pump.
- To install, tighten to 10 Nm (89 lb-in).
- NOTE:
Install a new coolant pump O-ring seal and lubricate with clean engine coolant.
To install, reverse the removal procedure.
- Fill and bleed the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding in this section.
Engine Cooling - Description and Operation
NOTICE: The engine cooling system is filled with Motorcraft® Premium Gold
Engine Coolant. Do not mix coolant types. Mixing coolant types degrades the corrosion
protection of Motorcraft® Premium ...
Coolant Expansion Tank
Item
Part Number
Description
1
8N029
Overflow hose
2
W701107
Coolant expansion tank bolt (2 required)
3
8C045
Coolant expansi ...
More about Ford Focus:
Ford Focus Instrument Panel Finish Panel - Center
Removal and Installation
All vehicles
NOTE: The instrument panel center finish panel should be replaced when
the Audio Control Module (ACM) or the HVAC module has been removed from the instrument
panel center finish panel more than once.
Lift the park brake lever.
Place the vehic ...
Nissan Frontier - Instrument Panel - Keys - Brake system
© 2016-2026 Copyright www.ffguide.net
