Ford Focus Service Manual: Crankshaft Main Bearing Journal-to-Bearing Clearance

Ford Focus Service Manual / Powertrain / Engine / Engine Block / Cylinder Block / Crankshaft Main Bearing Journal-to-Bearing Clearance

NOTE:

Refer to the appropriate Section 303-01 for the specification.

NOTE:

Crankshaft main bearing journals must be within specifications before checking journal clearance.

Remove the crankshaft main bearing caps and crankshaft main bearing.

Lay a piece of Plastigage across the face of each crankshaft main bearing surface.

NOTE:
Do not turn the crankshaft while carrying out this procedure.
Install and remove the crankshaft main bearing cap.

Verify the crankshaft journal clearance.

Crankshaft Main Bearing Journal Taper and Out-of-Round

NOTE: Refer to the appropriate Section 303-01 for the specification. Measure each of the crankshaft main bearing journal diameters in at least 2 directions at each end of the main bearing jou ...

Connecting Rod Bend

Special Tool(s) Feeler Gauge Set 303-D027 (D81L-4201-A) or equivalent NOTE: Refer to the appropriate Section 303-01 for the specification. Using the Feeler Gauge ...

More about Ford Focus:

Ford Focus Accessory Drive Belt
Removal and Installation With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02. Remove the 2 bolts and the accessory drive belt splash shield. To install, tighten to 9 Nm (80 lb-in). Using the hex feature, rot ...