Ford Focus Service Manual: Passenger Airbag Deactivation (PAD) Indicator - Removal and Installation
| Item | Part Number | Description |
|---|---|---|
| 1 | — | Passenger Air Bag Deactivation (PAD) indicator/ traction control switch electrical connector (part of 14401) |
| 2 | 7804302 | Instrument panel center finish panel |
| 3 | 13D730 | PAD indicator/ traction control switch |
Removal and Installation
NOTE:
The Passenger Air Bag Deactivation (PAD) indicator is part of the Hazard/ Traction control switch assembly.
- NOTE:
Ignition must be OFF when disconnecting the PAD indicator electrical connector. Otherwise, a DTC will be set in the Restraints Control Module (RCM) memory and must be cleared before releasing the vehicle.
Turn the ignition OFF and wait at least one minute.
- Remove the instrument panel center finish panel. For additional information, refer to Section 501-12.
- Disconnect the PAD indicator electrical connector.
- Disengage the lock tabs and remove the PAD indicator from the instrument panel center finish panel.
- To install, reverse the removal procedure.
Belt-Minder Deactivating/Activating - General Procedures
Preparation
NOTE: The driver and front passenger Belt-Minder® are deactivated/activated
independently. When deactivating/activating one seating position, do not buckle
the other position, as th ...
Warning Chimes - Description and Operation
NOTE: The Smart Junction Box (SJB) is also known as the Generic Electronic
Module (GEM) .
The warning chimes are designed to provide the driver with an audible warning
that acts as a supplementa ...
More about Ford Focus:
Ford Focus Wiper Pivot Arm
Removal and Installation
Lift up the covers and loosen the wiper pivot arm nuts approximately 2 turns.
Lift the wiper pivot arms and release them from the taper by moving them
to one side.
Remove the nuts and wiper pivot arms.
To install, tighten to 27 Nm (20 lb-ft).
...
Nissan Frontier - Instrument Panel - Keys - Brake system
