Ford Focus Service Manual: Steering Column Shaft
| Item |
Part Number |
Description |
| 1 |
3B676 |
Upper steering column shaft |
| 2 |
W706229 |
Upper steering column shaft-to-lower steering column shaft bolt |
| 3 |
W712882 |
Upper steering column shaft-to-steering column bolt |
Removal and Installation
- NOTICE: Do not allow the steering column to rotate while the steering
column shaft is disconnected, or damage to the clockspring may occur. If there
is evidence that the steering column has rotated, the clockspring must be removed
and recentered. For additional information, refer to Section 501-20B.
NOTE:
Use a steering wheel holding device (such as Hunter® 28-75-1
or equivalent).
Using a suitable holding device, hold the steering wheel in the straight-ahead
position.
- Remove and discard the upper steering column shaft-to-steering column bolt.
- To install, tighten the new bolt to 30 Nm (22 lb-ft).
- Remove and discard the upper steering column shaft-to-lower steering column
shaft bolt.
- To install, tighten the new bolt to 28 Nm (21 lb-ft).
- Collapse and remove the upper steering column shaft.
Removal and Installation
Item
Part Number
Description
1
—
Ignition switch electrical connector (part of 14401)
2
—
Electrical harness pi ...
Removal and Installation
Item
Part Number
Description
1
3600
Steering wheel
2
W705985
Steering wheel bolt
3
9C888
Steering ...
More about Ford Focus:
Ford Focus Tyre care
Tyre care
To make sure the front and rear tyres of
your vehicle wear evenly and last longer,
we recommend that you swap the tyres
from front to rear and vice versa at regular
intervals of between 5 000 and 10 000
km (3 000 and 6 000 miles).
CAUTION:
Do not scrub the sidewalls of the
t ...