Ford Focus Service Manual: Steering Wheel

Ford Focus Service Manual / Chassis / Steering / Steering Wheel and Column / Steering Wheel

Removal and Installation

Item	Part Number	Description
1	3600	Steering wheel
2	W705985	Steering wheel bolt
3	9C888	Steering wheel switches electrical connector

Remove the driver air bag module. For additional information, refer to Section 501-20B.

Turn the steering wheel to the straight-ahead position and turn the ignition switch to the OFF position.

If equipped, disconnect the steering wheel switches electrical connector.

Loosen the steering wheel bolt and install a suitable steering wheel puller.
- Install the 2 jaws of the puller into the 2 slots marked PULL.

Using a suitable puller, free the steering wheel from the steering column shaft.
- Remove the bolt and the steering wheel.
- To install, tighten to 40 Nm (30 lb-ft).

NOTICE: Do not allow the clockspring to turn from its removal position or damage to the clockspring may occur.

Tape the clockspring center rotor to the outer housing to keep it from rotating.

To install, reverse the removal procedure.

Steering Column Shaft

Item Part Number Description 1 3B676 Upper steering column shaft 2 W706229 Upper steering column shaft-to-lower steering column shaft bolt ...

Steering Wheel Rotation Sensor

Special Tool(s) Vehicle Communication Module (VCM) and Integrated Diagnostic System (IDS) software with appropriate hardware, or equivalent scan tool ...

More about Ford Focus:

Ford Focus Valve Seals
Special Tool(s) Compressor, Valve Spring 303-300 (T87C-6565-A) Compressor, Valve Spring 303-350 (T89P-6565-A) Compressor, Valve Spring 303-472 (T94P-6565-AH) Installer, Valve Stem Oil Seal 303-47 ...