Ford Focus Service Manual: Accessory Drive Belt Idler Pulley
Ford Focus Service Manual / Powertrain / Engine / Pulleys and Belts / Accessory Drive Belt Idler Pulley
Removal and Installation
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02.
- Remove the 2 bolts and accessory drive belt splash shield.
- To install, tighten to 9 Nm (80 lb-in).
- Using the hex feature, rotate the accessory drive belt tensioner clockwise and remove the accessory drive belt from the idler pulley.
- Remove the bolt and accessory drive belt idler pulley.
- To install, tighten to 48 Nm (35 lb-ft).
- To install, reverse the removal procedure.
Accessory Drive Belt
Removal and Installation
With the vehicle in NEUTRAL, position it on a hoist. For additional information,
refer to Section 100-02.
Remove the 2 bolts and the accessory drive belt ...
Starting System
...
More about Ford Focus:
Ford Focus Starting a petrol engine - E85
For general information on starting a
petrol engine. See Starting a petrol ngine.
Starting at low ambient
temperatures
When the temperature is lower than -10°C
(14°F) and the vehicle is filled with E85, an
engine block heater should be used to
facilitate starting. See Engine heater. Failure ...
© 2016-2019 Copyright www.ffguide.net