Ford Focus Service Manual: Door Lock Cylinder

Ford Focus Service Manual / Body / Doors and Enclosures / Doors / Door Handle to Latch Rod Adjustment / Door Lock Cylinder

Removal and Installation

Remove the front door exterior handle reinforcement. For additional information, refer to Door Handle Reinforcement — Exterior, Front in this section.

Release the clip and slide the door lock cylinder out of the exterior front door handle reinforcement.

NOTE:
Make sure to align the D-slot on the door lock cylinder with the D-slot on the door lock cylinder lever.
To install, reverse the removal procedure.

Door Handle to Latch Rod Adjustment

NOTE: An incorrectly adjusted exterior door handle can cause a loose handle, rattle noise, door hard to open from the outside door handle, or the outside door handle to not sit flush in the closed ...

Mode Door Actuator - Air Inlet Door

Item Part Number Description 1 — Air inlet mode door actuator electrical connector (part of 18B604) 2 — Air inlet mode door actuator sc ...

More about Ford Focus:

Ford Focus Reference Value Parameter Identification (PID)/Measured Signal Chart
The following listing reflects PIDS and/or measured values which may reveal a possible concern within each system shown. Match the category number with the related PID/measured signal and go to the Typical Diagnostic Reference Value Charts. PID/Measured Signal Chart Category Numbe ...

Nissan Frontier - Instrument Panel - Keys - Brake system