Ford Focus Service Manual: Mode Door Actuator - Air Inlet Door
Item |
Part Number |
Description |
1 |
— |
Air inlet mode door actuator electrical connector (part of 18B604)
|
2 |
— |
Air inlet mode door actuator screw (2 required) |
3 |
19E616 |
Air inlet mode door actuator (2-pin) |
Removal and Installation
- Remove the blower motor resistor. For additional information, refer to Blower
Motor Resistor in this section.
- Remove the 2 air inlet mode door actuator screws.
- Disconnect the air inlet mode door actuator electrical connector.
- Remove the air inlet mode door actuator.
- To install, reverse the removal procedure.
Removal and Installation
Remove the front door exterior handle reinforcement. For additional information,
refer to Door Handle Reinforcement — Exterior, Front in this section.
Release ...
Item
Part Number
Description
1
—
Defrost/panel/floor mode door actuator electrical connector (part of
18B604)
2
—
Defrost/panel/floor ...
More about Ford Focus:
Ford Focus Cylinder Block Distortion
Special Tool(s)
Feeler Gauge Set
303-D027 (D81L-4201-A) or equivalent
NOTE: Refer to the appropriate Section 303-01 for the specification.
NOTE: Use a Straightedge that is calibrated by the manufacturer
to be flat within 0.005 mm (0.0002 in) per running foot ...