Ford Focus Service Manual: Evaporator to Compressor Suction Line
Material
| Item |
Specification |
| Motorcraft® PAG Refrigerant Compressor Oil
YN-12-D |
WSH-M1C231-B |
| Item |
Part Number |
Description |
| 1 |
W520413 |
A/C compressor suction fitting nut |
| 2 |
W520413 |
Evaporator-to-compressor suction line fitting nut |
| 3 |
19E636 |
Evaporator-to-compressor suction line |
| 4 |
19B596 |
O-ring seal and gasket seal kit (2 required) |
Removal and Installation
- Recover the refrigerant. For additional information, refer to Section
412-00.
- Remove the A/C compressor suction fitting nut and disconnect the fitting.
- Discard the O-ring seal and gasket seal.
- To install, tighten to 15 Nm (133 lb-in).
- Remove the evaporator-to-compressor suction outlet line fitting nut and
disconnect the fitting.
- Discard the O-ring seal and gasket seal.
- To install, tighten to 15 Nm (133 lb-in).
- Remove the evaporator-to-compressor suction line.
- To install, reverse the removal procedure.
- Install new gasket seals and O-ring seals.
- Lubricate the refrigerant system with the correct amount of clean PAG
oil. For additional information, refer to Section 412-00.
- Evacuate, leak test and charge the refrigerant system. For additional information,
refer to Section 412-00.
Material
Item
Specification
Motorcraft® PAG Refrigerant Compressor Oil
YN-12-D
WSH-M1C231-B
Item
Part Number
Description
1
...
Material
Item
Specification
Motorcraft® PAG Refrigerant Compressor Oil
YN-12-D
WSH-M1C231-B
Item
Part Number
Description
1
...
More about Ford Focus:
Ford Focus Using the parking aid
WARNING:
The parking aid does not relieve you
of your responsibility to drive with
due care and attention.
The parking aid is automatically activated
when you select reverse gear with the
ignition switched on.
You will hear an intermittent tone at a
distance of approximately 150
centi ...