Ford Focus Service Manual: Turbine Shaft Speed (TSS) Sensor

Turbine Shaft Speed (TSS) Sensor

Removal

1. Remove the battery tray. For additional information, refer to Section  414-01.

1. Remove the Air Cleaner (ACL) assembly. For additional information, refer to Section  303-12.

1. Disconnect the Turbine Shaft Speed (TSS) sensor electrical connector.

1. Remove the TSS sensor bolt and sensor.
   • Check the TSS sensor bore.

1. Inspect the O-ring seal for nicks or cuts; install a new O-ring if necessary.

Installation

1. Apply a light coat of clean transmission fluid to the O-ring seal before installation.

1. NOTE:

   Apply thread sealer to the bolt.

   Install the TSS sensor and bolt.

   • Tighten to 10 Nm (89 lb-in).

1. Connect the TSS sensor electrical connector.

1. Install the ACL assembly. For additional information, refer to Section  303-12.

1. Install the battery tray. For additional information, refer to Section  414-01.