Ford Focus Service Manual: Reversing Lamp Switch - Removal and Installation

Ford Focus Service Manual / Body / Body Electrical / Lighting / Exterior Lighting / Reversing Lamp Switch - Removal and Installation

Item	Part Number	Description
1	—	Reversing lamp switch electrical connector (part of 13A690)
2	15520	Reversing lamp switch

Removal and Installation

Remove the battery tray. For additional information, refer to Section 414-01.

Disconnect the electrical connector and remove the reversing lamp switch.
- To install, tighten to 10 Nm (89 lb-in).

To install, reverse the removal procedure.

Exterior Lighting - Description and Operation

NOTE: The Smart Junction Box (SJB) is also known as the Generic Electronic Module (GEM) . The exterior lighting system consists of the following components: Headlamp assemblies Fog lamps ( ...

Fog Lamp - Removal and Installation

Sedan Item Part Number Description 1 15266 Fog lamp bezel 2 W706805 Fog lamp screws (4 required) 3 15200 Fog lamp ...

More about Ford Focus:

Ford Focus Key Programming Using Two Programmed Keys - General Procedures
NOTE: This procedure only works if 2 or more programmed ignition keys are available. If 2 keys are not available, refer to Spare Key Programming — Using Diagnostic Equipment in this section. NOTE: The Instrument Cluster (IC) PID SPAREKEY must be enabled for this procedure to operate. If th ...

Nissan Frontier - Instrument Panel - Keys - Brake system