Ford Focus Service Manual: Fog Lamp - Removal and Installation
Sedan
| Item |
Part Number |
Description |
| 1 |
15266 |
Fog lamp bezel |
| 2 |
W706805 |
Fog lamp screws (4 required) |
| 3 |
15200 |
Fog lamp |
| 4 |
— |
Fog lamp electrical connector (part of 14290) |
Coupe
| Item |
Part Number |
Description |
| 1 |
— |
Fog lamp electrical connector (part of 14290) |
| 2 |
N807011 |
Fog lamp screws (4 required) |
| 3 |
15200 |
Fog lamp |
Removal and Installation
NOTE:
Make sure the headlamp switch and the ignition switch are in
the OFF position.
Sedan or coupe
- With the vehicle in NEUTRAL, position it on a hoist. For additional information,
refer to Section 100-02.
Sedan
- Release the tabs and remove the fog lamp bezel from the front bumper cover.
Coupe
- For the RH fog lamp, remove the horn. For additional information, refer
to Section 413-06.
- For the LH fog lamp on Partial Zero Emissions Vehicle (PZEV) vehicles, remove
the air cleaner. For additional information, refer to Section 303-12.
Sedan or coupe
- Disconnect the fog lamp electrical connector.
- Remove the 4 screws and the fog lamp.
- To install, reverse the removal procedure.
- If necessary, adjust the fog lamps. For additional information, refer
to Front Fog Lamp Adjustment in this section.
Item
Part Number
Description
1
—
Reversing lamp switch electrical connector (part of 13A690)
2
15520
Reversing lamp switch
Removal ...
Fog Lamp Adjustment Screw Location
NOTE: Horizontal aim is not required for this vehicle and is not
adjustable. Consult your state vehicle inspection center for recommended tolerance
ranges ...
More about Ford Focus:
Ford Focus Safety Belt Procedure After a Collision
WARNING: After
any crash, all of the following safety belt assemblies and attaching hardware must
be inspected to verify correct function:
Retractors
Buckles
Belt tension sensor (BTS) (if equipped)
Front safety belt buckle support assemblies (slide bar) (if equipped)
Safety belt s ...