Ford Focus Service Manual: Washer Pump and Reservoir

Removal and Installation

1. Remove the washer fluid reservoir filler neck bolt.

1. Position aside the coolant overflow bottle.
   • Remove the 2 bolts and position the coolant overflow bottle aside.

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section  100-02.

1. Remove the radiator lower air deflector. For additional information, refer to Section  501-02.

1. Disconnect the washer pump electrical connector.

1. WARNING: Carefully
   read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.

   NOTE:

   To prevent spilling windshield washer fluid, drain the windshield washer reservoir before removal.

   Disconnect the washer pump hose. For additional information, refer to C-Lock Coupler in this section.

1. Remove the windshield reservoir.
   • Remove the nut and 2 bolts.
     • To install, tighten to 5 Nm (44 lb-in).

1. NOTICE: Do not operate the washer pump prior to filling the windshield washer reservoir. Failure to follow these instructions may result in premature pump failure.

   To install, reverse the removal procedure.