Ford Focus Owners Manual: Autowipers
CAUTIONS:
Do not switch autowipers on in dry weather conditions. The rain sensor is very sensitive and the wipers may operate if dirt, mist or flies hit the windscreen.
Replace the wiper blades as soon as they begin to leave bands of water and smears. If you do not replace them, the rain sensor will continue to detect water on the windscreen and the wipers will operate, even though the majority of the windscreen is dry.
Fully defrost the windscreen in icy conditions before you switch autowipers on.
Switch autowipers off before you enter a car wash.
Autowipers
Low sensitivity A On B High sensitivity C
If you switch autowipers on, the wipers will not cycle until water is detected on the windscreen. The rain sensor will then continuously measure the amount of water on the windscreen and adjust the speed of the wipers automatically.
Adjust the sensitivity of the rain sensor using the rotary control. With low sensitivity, the wipers will operate when the sensor detects a lot of water on the windscreen. With high sensitivity, the wipers will operate if the sensor detects a small amount of water on the windscreen.
Windscreen wipers
Windscreen wipers
Single wipe A
Intermittent wipe or autowipers B
Normal wipe C
High speed wipe D
Intermittent wipe
Long wipe interval A
Intermittent wipe B
Short wipe interval C
Auto ...
Windscreen washers
Windscreen washers
WARNING:
Do not operate the washer for more
than 10 seconds at a time, and
never when the reservoir is empty.
While the button at the end of the lever is
pressed the was ...
More about Ford Focus:
Ford Focus Safety Belt Maintenance
Inspection
WARNING: All safety
belt components must be inspected and corrected as part of any collision repair.
Inspect all safety belt components as prescribed by Safety Belt Inspection and Repair
After a Collision found in Section 501-20A General Procedures of this manual. Failure
to fol ...
Nissan Frontier - Instrument Panel - Keys - Brake system
