Ford Focus Service Manual: Transaxle Support Insulator - LH
Ford Focus Service Manual / Powertrain / Transmission/Transaxle / Transmission Mounts / Transaxle Support Insulator - LH
Special Tool(s)
|
Adapter for 303-290A 303-290-01 |
|
Adapter for 303-290A (Support Leg) 303-290-03A |
|
Support Bar, Engine 303-290A |
| Item | Part Number | Description |
|---|---|---|
| 1 | W700069-S | Battery tray nut (3 required) |
| 2 | 10723 | Battery tray |
| 3 | W703457-S | LH transaxle support insulator nut (4 required) |
| 4 | W520215-S | LH transaxle support insulator nut |
| 5 | 7M121 | LH transaxle support insulator |
| 6 | W710090-S | PCM/battery support bracket bolt (3 required) |
| 7 | 6K034 | PCM/battery support bracket |
| 8 | 12A651 | PCM |
| 9 | W520413-S | PCM nut |
| 10 | W500614-S | PCM bolt |
| 11 | W706777-S | LH transaxle support insulator bracket bolt (3 required) |
| 12 | 7M125 | LH transaxle support insulator bracket |
| 13 | — | Resonator bolt (2 required) |
| 14 | — | Resonator |
| 15 | — | Intake air hose |
- Remove the battery. For additional information, refer to Section 414-01.
- Release the 2 wiring harness pushpins, then remove the 3 battery tray nuts
and the battery tray.
- To install, tighten to 12 Nm (106 lb-in).
- Install the Engine Support Bar and Adapters.
- Remove the 5 LH transaxle support insulator nuts and the LH transaxle support
insulator.
- To install, tighten the center nut to 150 Nm (111 lb-ft).
- To install, tighten the outer nuts to 48 Nm (35 lb-ft).
- To install, reverse the removal procedure.
Transaxle Support Insulator
Item
Part Number
Description
1
W702826
Roll restrictor-to-subframe bolt
2
W702801
Roll restrictor-to-transaxle bracket bolt
3
6P ...
Transaxle Support Insulator
Special Tool(s)
Adapter for 303-290
303-290-01
Adapter for 303-290A (Support Leg)
303-290A-03A
Support Bar, Engine
303-290A ...
More about Ford Focus:
Ford Focus Timing Drive Components
Removal
NOTICE: Do not loosen or remove the crankshaft pulley bolt without first installing
the special tools as instructed in this procedure. The crankshaft pulley and the
crankshaft timing sprocket are not keyed to the crankshaft. The crankshaft, the
crankshaft sprocket and the pulley are ...
© 2016-2026 Copyright www.ffguide.net
